Garage Door Repair Services › Garage Door Spring Repair

Garage Door Spring Repair in Carrollton, TX

Springs do the actual lifting — the opener just signals when to move. When a spring snaps, the door becomes dead weight and won't budge, even manually. We replace springs matched to your door's exact weight so they last a normal lifespan instead of failing early.

Call (469) 557-4480

When to Call

When You Need Garage Door Spring Repair

You heard a loud bang in the garage and the door won't open
The door moves a few inches then stops and reverses
One side of the door hangs lower than the other
The opener strains and hums but the door barely lifts
You can see a visible gap in the coil on the spring bar
The door only opens manually with significant effort from two people

How It Works

Our Process for Garage Door Spring Repair

1

Measure the door

We weigh the door and measure the opening before touching anything. Spring sizing depends on actual door weight, not just the door dimensions.
2

Identify spring type and failure

Most Carrollton homes have torsion springs above the door. Older homes sometimes have extension springs on the sides. We check both and note which failed.
3

Release tension safely

A wound spring holds serious stored energy. We release it using winding bars, not improvised tools. Skipping this step is how injuries happen.
4

Install correctly sized replacements

We install springs rated for your door's weight and cycle count. A spring that's too light fails early. One that's too heavy makes the opener work too hard.
5

Test balance and operation

We disconnect the opener and manually check balance. A balanced door should hold position at mid-height without drifting up or dropping.
6

Reconnect and cycle the door

After balance is confirmed, we reconnect the opener, run several full cycles, and verify the auto-reverse limits are still set correctly.

What's included

Measurement and weight assessment before any parts are ordered or installed
Removal of the broken spring and hardware disposal
Installation of replacement spring or springs sized to your door
Balance test and manual operation check after installation
Opener reconnection and cycle testing before we leave
Basic lubrication of the spring shaft and bearing plates

What's not included

Cable replacement if cables are frayed or damaged — that's a separate repair
Opener repair if the motor was damaged from operating with a broken spring
Panel or track straightening if the door was forced open before we arrived

Real Situations

Common Scenarios in Carrollton

A homeowner in Carrollton's Prestonwood Park neighborhood came home to find their car trapped inside after the spring snapped during the afternoon heat.

We confirm the door is fully disengaged from the opener before measuring. We carry common spring sizes on the truck, so most single-car door springs are replaced the same visit without a parts run.

A homeowner noticed one side of their two-car door sagging and assumed the track was bent.

A sagging side on a two-car door usually points to one broken spring on a dual-spring system. We inspect both springs even if only one has visibly failed, because the second one is typically near the end of its life too.

An older home near Old Bent Tree had extension springs instead of a torsion system, and one snapped and came off the pulley.

Extension springs require a different approach — we check the safety cables threaded through them, which contain the spring if it snaps again. We replace both springs and verify the safety cables are intact.

Carrollton Context

Why this matters in Carrollton

Carrollton's temperature swings are hard on springs. Summer attic temperatures in a closed garage regularly push past 130 degrees, and that heat cycling shortens spring life faster than normal use does. Many homes built in the 1980s and 1990s in communities like Keller Springs and Josey Ranch still have original hardware, which means springs that are well past their designed cycle count.

Straight Talk

About pricing & scope

Spring pricing varies based on door weight, spring type, and whether you have one spring or two. Heavier doors and two-spring systems cost more in parts. If we find cable or roller damage during the job, we'll tell you before touching anything extra — not after.

What This Fixes